|
Post by koolbraider on Aug 29, 2016 9:18:36 GMT -6
I wasn't sure where to post this but here goes: has anyone had a problem with Fusion Beads' site? I get only the background, which means the site is there, kinda. There was that annoying circling beads cursor once but nothing now. I'm getting a bit worried because that's one of my favorite go-sites. Does anyone else have the same problem?
|
|
|
Post by caeterle on Aug 30, 2016 10:55:19 GMT -6
This was posted on Facebook yesterday. "We apologize for the technical difficulties with the website over the weekend and for any inconvenience this may have caused. We had a brief site outage but this issue has now been fixed. Our website is back up and running as normal!" There were several comments that people still can't load the site, though. Neither could I at the first attempt. It looked just like a background picture.
Then I checked isup.me (downforeveryoneorjustme) and it said the site was not down, you get the link again then, I clicked in and it loaded right away.
|
|
|
Post by koolbraider on Aug 30, 2016 11:55:38 GMT -6
Many thanks, Cat. I didn't think of Facebook. After a few seconds it loaded. I was dreading doing something computer geeky that needed to be done. (Geeky?)
|
|
|
Post by caeterle on Aug 30, 2016 12:11:51 GMT -6
I often found updates on Facebook and sometimes it's easier to get an answer from some companies there than if you write to support. I think it should be the other way round!
|
|